’74 Scamp Control Arm Stud Tube
Tech Question
mark tatman, chillicothe OH, 1974 plymouth scamp 318
My front passanger side tire leans in at the top, it grabswhen going into a curve, would this be a upper or lower ball joint? Orsomething else? I noticed it…
SuperBird/Daytona Differences
Tech Question
Bryan Allard, East Burke, VT, 1970, dodge, Charger Daytona, 426
We are having a dispute over the Plymouth SuperBird andthe Dodge Charger Daytona. My roommate says that that they are different.My friend says that they…
8-1/4″ Rear For ’72 Scamp
Tech Question
Kenneth Goucher, Connellsville PA , 1972 Plymouth Valiant Scamp 225
My car currently has a 6-cylinder / 3-speed manual which Iplan to swap a 318 / A-833 combo into. I need to swap out the stock 7 1/4"rear for somthing…
’84 440 Ram Charging
Tech Question
Clay Cooke
I have an '84 Dodge Ram with a 440. I swapped in the engine over this last summer, and ever since then I have had problems with the charging system. Power is getting lost somewhere, and I dont know where.…
’66 Dart 225 Oil Pressure
Tech Question
michael sloterdike, noel, MO, 1966 Dodge Dart 225
Can you tell me what the oil pressure should be when cold andat idle and cruising speed after the oil has warmed up? I love this stationwagon the engine was overhauled…
413 Swap Into ’88 Dakota
Tech Question
grant harvey, albuquerque, NM, 1988 dakota 2-wheel, std cab 413?
Want to put an early 413 in the Dakota, motor mounts, exhaustmanifolds all look doable. Will BB pan fit OK nestled right behind thatfront cross member…
340 Cam Install
Tech Question
mike priore, highland mills, NY. 71 plymouth barracuda 340
I am considering installing the mp .474 camshaft in my 71cuda 340. Is it absolutlely neccessary to degree this cam or can it beinstalled straight up without a…
Cross-Threaded Rear
Tech Question
Mike Eaton, Minot, Nd, 71 Dodge Charger 318
I Had My Rearend Rebuilt Recently
(489 Casting With richmond 4.10 Gears, Has 10 Spline Yolk And The Big U-joint)
And I have Crosthreaded One Of The Holes That Secures The…
Torque Converter Bolts
Tech Question
Tom Gipe, Cypress, CA, 1968 Dodge Charger R/T 572
Dear Rich, I'm a long time subscriber and have a question. Idrag race my 1968 Charger a little and when I get a really good full powerlaunch the torque converter bolts…
Rear for ’87 360 Dakota
Tech Question
ike haney, cookeville TN, 1987 Dodge Dakota 360
Hi, I have a little project in my shop right now- an '87Dakota, frame off, '77 360, 10:1 flat tops, '70 340 J heads ported andpolished, Edelbrock Streetmaster intake,…