Browsing Category
Powertrain/Axles Tech
Mopar powertrain and axle questions submitted by our readers and answered by our technical editors.
Mileage Gears For ’86 Pickup
Tech Question
kent goodall, paola, KS, 1986 dodge pickup 383
I have a 1986 dodge pickup with a 383 bored 0.030" over,and a 727 trans. The trans, driveshaft, and 8-3/4" rear are out of a 77Cordoba. The rear diff has 3.23 gears. My…
Gears In ’78 Magnum XE
Tech Question
earl sexton, owingsville, KY, 78 dodge magnum xe 71 440
I have a 78 Magnum XE that came with a 400" big block. Iput a '71 440 out of an Imperal in it; I bored it 0.030" over. It has OEMCarter AVS carb. It is all Mopar…
8-1/4″ Rear C-Clips
Tech Question
pete stone, louisville, KY, 1964 plymouth Valiant 318
In a recent tech question about axles, you mentioned theuse of the 8-1/4" as an alternative. Since I have been unable to locate a8-3/4" for my A-body I would like…
Driveshaft length 904 vs. 727
Tech Question
Bill Reese, Panacea, FL, 1989 Dodge Pick-up Short bed 360
I swapped the orginal 318 to a 360 engine and the orginaltrans is a 904 type. I'm planning on swapping it out for a 727. My questionis related to drive shaft…
Rear End ID
Tech Question
Dick Scaife,, Perth, Western Australia, 70 Valiant VG 2 Door 383
Mr. Ehrenberg, Hi, I just found a diff, looks like a Dana,but I think it's a small one (not a 60). The housing numbers are 48674 -3723599, preceded by a…
Manual Trans For Stroker ’68 Coronet
Tech Question
Steven Duke, Elmira, NY, 68 Dodge Coronet 512
I want to thank you for all the help you have given me in the past haveone more question for ya--I have a 68 coronet with a 512 stroker & built 727trans, 3:73 Dana…
8-1/4″ Rear Behind A 440
Tech Question
Wade Carrier, Rock Island, TN, 1977 Plymouth Volare 440
Ive got a 1977 Plymouth Volare station wagon that Imputting a 440 in. Right now I currently got an 8-1/4" 2.94 Sure Grip rearend out of an 83 Gran Fury police…
Scampy Scamp
Tech Question
elliot rivera, bronx, NY, 1972 plymouth scamp, 440
I want my Scamp to run in the low 11-sec. bracket. What Ihave is stock stroke and bore '67 440, stock bottom end including pistons,Eddy heads, Vic intake, 0.528" MP…
Green Ball Bearing Install
Tech Question
Shannon Fuller, Salisbury, Australia, 1970 Dodge Challenger 440
I'm a long time reader of MA and always enjoyed your tech articles. I havefinally got a problem that hopefully you can help me with. On my '70…
Auburn Rear Lube
Tech Question
Rojohn Soriano, Puyallup, WA, 1972 Dodge Challenger 318
Hello again. I would like to know your recommendation on which Sure Griplubricant additive you would use for the aftermarket Auburn Sure Gripdifferential…