Browsing Category

Tech

Torsion Tweak

I would like to upgrade my ’68 CoronetSuper Bee (383) from 0.88˝ to 0.96˝ torsionbars. How hard is it to swap them?Anything else need to be removed? Anyof your famous tips or tricks?It is really pretty easy, especially whencompared to

A Slap In The…

What causes piston slap noise on a newlyrebuilt motor? I had my 440 rebuilt at avery well-known Mopar shop, they goback to the ’60s. It was bored .30 over,9:1 C.R. pistons, 452 heads and a 0.484˝Mopar cam. It has very good oil pressure.60

B-Van Plan

I enjoyed the recent story on the DodgeVan racing in Japan. But I have a question:I know these vans were accusedof being ill-handling, and many 15-passengerchurch vans, etc., rolled over andkilled lots of people. How did they evermake them

Time To Run

I am assembling an enginefor a dead-stock 1970Swinger 340, 4-speed. Themachine shop that rebuiltthe short block says thatwith today’s gasoline, thetotal timing should probablybe 33 degrees or so.I have seen where youhave written it should

Cool Aluminum Cold Copper

I see everybody using aluminum radiators.How do they stay cool? Copper, asI am sure you know, transfers heat betterthan aluminum. What am I missing?You are correct about the Cu vs. Al heattransfer specs. What you are missing,though, is

Grinding Gears

I have a ’70 ’Cuda, 512˝ wedge, that Idrag race about six times a year. It has ablow-proof scattershield. Twice now, theflywheel ring gear and the starter teeth, have gotten chewed up, which is gettingexpensive.What the heck is

Back Braking

I read everything in the last 2issues about your rear discbrake swap. I have a 1997Grand Cherokee, and the brakeslook the same. Why is the Libertystuff you used better?Yes, the XJ stuff looks similar,but it isn’t the same:a. The GC (XJ)

Ruskie Runner

I was in the Russian city of Novosibirskfor work for a few weeks. While there, Isaw, twice, a car that looked very muchlike a Chrysler Sebring or Stratus, it said“Volga Siber 2.4L.” Once I saw the guygetting into it, and tried to speak to

Size Matters

I have played around with Chryslerproducts for about 15 years, both myparents and grandparents had them.My grandmother recently left me her1970 Satellite, 318, 4-door, automatic.It only has 67,000 miles on her. She hadbeen sitting only 2

Block Plug In Oil Passage

I bought recently a 360 1975 Dart Sport,107K. The oil light was flickering at idlesometimes, so I installed a gauge. It dipsas low as 12-15 PSI sometimes in gear,when it is hot. I am told that there is someoil plug in the block that may

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More