Wiring Resistor/Regulator

Tech Question


Eddie, Laredo, TX,72, Dodge, Demon, 340

I am having a problem with my conversion wiring. How do youconnect the voltage regulator to the resistor? I’mcahnging my ignition toelectronic, I am using a two-pronged resistor.



you don’t. It’s as simple as that. The voltage regulator wiringremains unchanged. Assuming you bought either the MP kit or the MP harness,most of the wiring is pretty much “pre-done” for you (ECU and magneticpickup coil.) All you have to do is to connect the 2 wires to igntion startand ignition run, as per the MP diagram and instructions, and put a lug onthe coil neg wire after cutting it to the correct length.


Comments are closed.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More