Green Bearings For 8-3/4″ Axles

Tech Question


Tom Crews, St Peters, MO , 1967 Plymouth Barracuda 383

What is the scoop on the Green bearings for the 8-3/4 rear axles? I read in the mags that these are “drag-race only” and not for street use. But I see them advertised every where and the replacement axles only work with these bearings. I have a ’67 cuda that I have an A-body 8-3/4 rearend for and want to convert to the 5 lug on 4-1/2 inch bolt pattern using the standard axle bearings. Where can I get such an animal? Keep up the great work! Thanks Tom C


The ball-type conversion bearing are short lived in street use andespecially not recommended in cornering applications – they have a smallfaction of the load rating as the stock Timkens.

You can either buy some purpose-built axles (Moser, Yukon, etc.) or have apair of C-body axles shortened, then use stock Timkens, properly packed withgrease and adjusted. This is 100,000-mile-plus durability stuff.


Comments are closed.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More