Measure Driveshaft
Tech Question
john johnston, murchison, TX, 1971 Plymouth valiant 360
Oh great one, I have 1971 Valiant 4 door sedan and I pulledthe 318 and swapped in a 360. After dropping in the 360 I realized I neededto swap the tranny 904 for the 727, so how do I measure to have the driveshaft shortened, car has 8.75″ axle, stock as far as I know
John
Have car supported by wheels or suspension, level. Slip in the yoke so there’s about 3/8″ clearance to the rear of the seal boot. Measure from the center of the U-joint hole to the front edge of the rear axle flange, that dimension is known as C/C.
Rick
Comments are closed.