|
|
Tech Question
Kenny East, Rixeyville, VA, 73 Plymouth Cuda 416
I pulled the 8.75" center section out to have new gears
installed and want to know if I have to replace inner axle seals before
re-installing axles? (The current seals have less than 1000 miles).
Thanks
Kenny-
No, just be very careful not to cut them with the sharp spline edges as you slide the shafts in. I usually wrap the splines with paper, slide the shafts in past the splines, then loosen my grip on the paper to pull it out.
Rick
| Next | Index | Previous |
|---|