|
|
Tech Question
Dan Edwards, Baltimore, MD, 1970 Challenger R/T
Hey E-man, I want to convert my stock clutch linkage to hydraulics. Can I pirate the works from a J-yard Ram or Dakota? I have a Challenger big block with the 833 box and just want some smoother action and to lose the clutter down in that area. Thank You.
Dan, sure, but it hardly seems worth re-inventing the wheel, both the master and slave ends will require lots of fabrication. Since Keisler has already done this, I think their kit, which includes a Mopar-specific, drop-in hydraulic release bearing, is the way to go.
But if you're pinching pennies, and value your labor at about 50 cents an hour, the stock hydraulic setup from slant six pre-'94 Ram pickups would probably be easiest to adapt.
Rick
| Next | Index | Previous |
|---|